![]() ![]() Take your hammer and tap the wire shelving lightly from the top so that the shelving makes a dimple in the wood. Line up the wire shelving on the wood side piece exactly where you want it, being aware of what the top, bottom and back is. Only you will see it so it doesn't have to be perfect! Quickly hand sand the pieces smooth to remove splinters. Cut one curve, then transfer that by tracing with a pencil to the other piece. I cut curves on both ends for aesthetic reasons, and also to give a place to screw the wood to the inside of the cabinet door. I cut the wood side pieces with a jigsaw using a fine tooth wood blade. I cut the wire shelving 17" long with a jigsaw using a metal blade, cutting in the center between rows, leaving prongs of about 3/8" long. I decided that a height of 17" was perfect to fit both the cabinet door, and the wire shelving material.ġ7" was also perfect for the inside width of the cabinet my door, leaving approximately an inch on either side clear so the door will close properly. I found that a scrap of 1x4 cedar that I happened to have was the perfect size to fit that box, leaving another 1/2" or so for installing the wire shelving. My plastic wrap box was the deepest at 3". ![]() Measure the depth of the largest item you want to store on the rack, as well as the longest. (I had to remove a shelf and trim it, which was no problem). Be sure to consider that you will need some clearance to close the door without the holder banging into the inside shelf. Once complete, you can click Close to close the File Manager window.Measure the inside dimension of your cabinet door and decide how wide, tall and deep you want to make your holder.If not, correct the error or revert back to the previous version until your site works again. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |